Ask the Pros
Jul 12th, 2010 |
By Editorial Staff |
Category: Ask the Pros, Ed Johnson
QUESTION: I read an article in a past issue of Tow Times about the new laws on hours driving and hours off in between shifts. It also mentioned what constituted driving hours with relation to standby hours.I would appreciate any help. ANSWER: The new hours-of-service [...]
Posted in Ask the Pros, Ed Johnson |
No Comments »
Jun 21st, 2010 |
By Editorial Staff |
Category: Ask the Pros, Jack Schrock
QUESTION: We know of a tower in Wisconsin who we think deserves to be inducted into the International Towing and Recovery Hall of Fame and Museum. How do we nominate this person? ANSWER: Contact the ITRHFM in Chattanooga for info on induction into the Hall [...]
Posted in Ask the Pros, Jack Schrock |
No Comments »
Jun 12th, 2010 |
By Editorial Staff |
Category: Ask the Pros, Steve Young
QUESTION: I was told that there was an article that warned people from attempting to unlock vehicles with a slim jim. I am a Police Officer in a small town and I was told by a tow truck driver of the issue.I would like to [...]
Posted in Ask the Pros, Steve Young |
No Comments »
Jun 12th, 2010 |
By Editorial Staff |
Category: Ask the Pros, Mike Scheidt
QUESTION: I was sent out the other day on a call which involved lifting up a trailer that had the landing legs taken out from under it. The trailer had a load of 47,000 lbs. minus the weight of the chassis and was at a [...]
Posted in Ask the Pros, Mike Scheidt |
No Comments »
Jun 12th, 2010 |
By Editorial Staff |
Category: Ask the Pros, Tom Luciano
QUESTION: I was on a tow a couple of weeks ago and had to use your u-bolt forks on a 6*6 Freightliner. I know they are made for rear tows but what about from the front like on awd drive mixers and the 6*6 Freightliner [...]
Posted in Ask the Pros, Tom Luciano |
No Comments »
Jun 12th, 2010 |
By Editorial Staff |
Category: AP McDonald, Ask the Pros
QUESTION: What is the name of the tool used to remove axles from buses and semis? ANSWER: Often the axle is slid out by hand after it is released and there are specialized tools to help with the release such as tapered cone pliers, but [...]
Posted in AP McDonald, Ask the Pros |
No Comments »
Jun 12th, 2010 |
By Editorial Staff |
Category: Ask the Pros, Jon Wickham
QUESTION: Our cable on a 20 series Chevron carrier flattens in less than three weeks. Winch is rated at 12,000 lbs. Not sure if we are getting the right cable or may the cable is too short. ANSWER: It’s very important to get the right [...]
Posted in Ask the Pros, Jon Wickham |
No Comments »
Jun 12th, 2010 |
By Editorial Staff |
Category: Ask the Pros, Ed Johnson
QUESTION: I’ve been in the towing and recovery buisness in northern Utah for about 3 1/2 years. I’m going to start my own tow company. Any words of advice on how to get my business going? ANSWER: First, find out what the costs are in [...]
Posted in Ask the Pros, Ed Johnson |
No Comments »
Jun 12th, 2010 |
By Editorial Staff |
Category: Ask the Pros, Jack Schrock
QUESTION:Is there a standard percentage of a hydraulic wrecker’s capacity that would be the limit of extending and retracting the boom under a load. I know that one is to position the elevation and extension of the boom, and then lift and lower the load [...]
Posted in Ask the Pros, Jack Schrock |
No Comments »
May 12th, 2010 |
By Editorial Staff |
Category: AP McDonald, Ask the Pros
QUESTION: Our cell phone provider wants to get rid of anolog cell phones. Does anyone make a phone that can be hard mounted in a truck? A large display, speaker phone and external antenna would be great. Do any have GPS tracking ability? ANSWER: From [...]
Posted in AP McDonald, Ask the Pros |
No Comments »